Snapper CZT19481KWV, Инструкции по безопасности и руководство оператора

Страница: 28 / 40

28
Section 3 - OPERATING INSTRUCTIONS Section 5 - ADJUSTMENTS & REPAIR
5.11 HYDRAULIC SYSTEM, PURGING
After replacing or repairing hydraulic system compo-
nents, one or both of the wheel drives may not pull
properly. This is likely to be caused by air entrapped in
the system. If you experience a pulling issue after
completing repairs, perform the following procedure to
purge the air from one or both of the hydraulic drive
systems.
IMPORTANT: WHEN REPLACING THE HYDRAULIC
FLUID FILTER, PRE-FILL WITH OIL (SAE 20W50 API
SL) BEFORE INSTALLING. PRE-FILLING THE FILTER
WITH OIL WILL REDUCE OR POSSIBLY ELIMINATE
THE NEED TO PURGE THE SYSTEM OF ENTRAPPED
AIR
1. Locate hydraulic reservoir underneath operator's
seat. After thoroughly cleaning the area around the top
of the reservoir, remove filler cap. Bring fluid to proper
level (1 ½" below the top of the filler neck). With
engine off, add SAE 20W50 automotive oil. See Figure
4.6.
2. Open pressure relief valve on hydraulic pump, turn-
ing counter clockwise 2 full turns. See Figure 3.3.
3. Carefully raise the rear of the machine so the
wheels are off of the ground. Securely block the
machine to prevent it from falling.
4. While seated in the operator's position, start the
engine. Place engine speed control in FAST position.
5. Release parking brake and move motion control
levers out of the neutral lock position.
6. Slowly move motion control levers to the full for-
ward and then to the full reward positions. Repeat this
process 6 times.
7. Stop engine and wait for all rotation to stop before
leaving the operator's position.
8. Close pressure relief valve on hydraulic pump, turn-
ing clockwise. Tighten snuggly.
9. With pressure relief valve closed, repeat Steps 4
thru 7.
10. Remove blocks and lower rear of machine.
11. Check fluid level in reservoir. Add SAE 20W50
automotive oil as required to bring fluid level to 1-½"
from top of filler neck. Do Not over fill.
12. Install and tighten filler cap.