Snapper CZT19481KWV, Инструкции по безопасности и руководство оператора

Страница: 11 / 40

11
Section 3 - OPERATING INSTRUCTIONS Section 3 - OPERATING INSTRUCTIONS
ROLL RELEASE: To roll the machine without the
engine running, pressure within the hydraulic pumps
must be released. There is a hydraulic pressure relief
valve on the upper side of each pump that is used to
release the pressure. Use a wrench to rotate both relief
valves counter clockwise two full turns to open. After
rolling machine, both relief valves must be rotated
clockwise to close valves and tighten securely before
operating machine. Machine will not move if relief
valves are open. See Figure 3.4. 3.2 STARTING & STOPPING - ENGINE, BLADES,
PARKING BRAKE
3.2.1. STARTING ENGINE
When the ignition key is turned the engine will not start
or turn over unless the blade switch is pushed in to the
"OFF" position and the motion control levers are in the
neutral lock position. Always engage parking brake
before starting engine.
1. Complete pre-start checklist.
2. Sit in operator's seat.
3. Push blade switch in to "OFF", blades disengaged
position and engage parking brake. See Figure 3.2.
4. Move choke control forward to choke position to
start a cold engine. See Figure 3.5.
5. Move engine speed control to the Rabbit "FAST"
position. See Figure 3.5.
6. Turn key to the start position until engine starts.
See Figure 3.6.
NOTE: If after 5 seconds of cranking the engine does
not start, release the key. Attempt starting again after
waiting for approximately 20 seconds.
7. After engine starts, move the choke control to the
"OFF" or no choke position. Allow a brief warm-up
until engine runs smooth.
FIGURE 3.4
WARNING
DO NOT disengage the hydro transmission and
coast down slopes. DO NOT use Roll Release
Control to disengage the hydro transmission
unless machine motion can be controlled and
engine is off.
!
!
RELIEF VALVE
ROTATE RELIEF VALVE
COUNTERCLOCKWISE TO
RELIEVE PRESSURE
CHOKE
CONTROL ENGINE SPEED
CONTROL
KEY SWITCH
MOTION CONTROL
LEVERS SHOWN IN
THE NEUTRAL
LOCK POSITION
FIGURE 3.5
SHOWN FROM OPERATOR'S VIEW POINT