Snapper Pro 5901280, Руководство оператора

Страница: 41 / 56

Not for
Reproduction
7. Perform the Determining if the Deck Leveling Needs to be
Adjusted procedure to verify that the deck has been leveled
correctly.
• If the mower deck does not measure 4" (10,2 cm) in
the front and 4-1/4" (10,8 cm) in the rear, proceed with
step #8.
8. Loosen the jam nut (A) and turn the fine adjustment bolt (B)
to adjust the deck height.
• Turn the bolt clockwise to raise the deck.
• Turn the bolt counter-clockwise to lower the deck.
9. Once the desired measurements are achieved, re-tighten
the jam nut.
10. Repeat the process for the other side of the unit.
Deck Leveling Adjustment (72" Mower Decks)
1. Place the deck height adjustment pin in the 4" (10,2 cm)
position.
2. Loosen the jam nut (A, Figure 64) on the deck linkages (B).
64
3. Turn the hex adjusters on the deck linkages (C) clockwise
to raise the mower deck or counter-clockwise to lower the
mower deck.
Note: If you are lowering the mower deck measure the amount
of visible threads (D) on the deck linkages. If the amount of
visible threads shown reaches 1-1/2" (3,8 cm), do not lower the
mower deck by adjusting the deck linkage any further.
4. Re-check the measurements from the tips of the mower
blades to the ground. The front measurements should equal
4" (10,2 cm) and the rear measurements should equal 4-1/4"
(10,8 cm).
• if the measurements equal 4" (10,2 cm) in the front and
4-1/4" (10,8) in the rear, tighten the jam nuts on the
deck linkages. The adjustment procedure is complete.
• If the measurements do not equal 4" (10.2 cm) in the
front and 4-1/4" (10,8) in the rear, the hole that the deck
linkage is mounted in on the mower deck will have to
be changed.
5. Place blocking underneath all four corners of the mower
deck.
6. Re-position the hardware (A, Figure 65) that secures the
deck linkage to the mower deck.
• If the mower deck was being raised when it was unable
to achieve the 4" (10,2 cm) in the front and 4-1/4" (10,8)
in the rear measurements, position the hardware in the
next lower hole (B) in the mower deck mount (C).
• If the mower deck was being lowered when it was
unable to achieve the 4" (10,2 cm) in the front and
4-1/4" (10,8) in the rear measurements, position the
hardware in the next higher hole in the mower deck
mount.
65
7. Remove the blocking from under the mower deck.
8. Re-check the measurements from the tips of the mower
blades to the ground. The front measurements should equal
4" (10.2 cm) and the rear measurements should equal 4-1/4"
(10,8 cm).
• if the measurements equal 4" (10,2 cm) in the front and
4-1/4" (10,8) in the rear, tighten the jam nuts on the
deck linkages. The adjustment procedure is complete.
• If the measurements do not equal 4" (10,2 cm) in the
front and 4-1/4" (10,8) in the rear, turn the hex adjusters
on the deck linkages until the measurements equal 4"
(10.2 cm) in the front and 4-1/4" (10,8 cm) in the rear.
9. Tighten the jam nuts on the deck linkages.
41