Snapper Pro 5901280, Руководство оператора

Страница: 36 / 56

Not for
Reproduction
2. Remove the pedal mount hardware (C) and rotate the tab
180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the proper
orientation as shown in Figure 50.
Floor Pan Removal & Installation
This unit is equipped with a removable floor pan which can be
removed to provide better access to the mower deck.
1. Loosen and remove the retaining hardware (A, Figure 51)
that secures the floor pan to the frame of the unit.
51
2. Tilt the back end of the floor pan up and then remove it from
the unit.
3. To re-install the floor pan: Reverse the removal procedure.
Neutral Adjustment
If the zero-turn rider “creeps” while the ground speed control
levers are locked in the NEUTRAL LOCKOUT position, then it
may be necessary to adjust the linkage rod.
Note: Perform this adjustment on a hard, level surface such as
a concrete floor.
1. Disengage the PTO, engage the parking brake and turn off
the engine.
2. There are two nuts (B, Figure 52) on the linkage rod. Loosen
the nuts from the ball joints and turn the linkage rod (A) to
adjust.
52
• If the machine creeps forward, turn the rod clockwise
(while standing at the rear of the machine, facing
forward);
• If the machine creeps backward, turn the rod
counter-clockwise.
3. Lock the nuts (B) against the ball joints when neutral is
achieved.
Note: This adjustment should not be performed while the
machine is running. It may take several attempts to achieved
neutral, depending upon how much the machine creeps.
Return-to-Neutral Adjustment
The return-to-neutral function is a feature of the transmissions
on this unit. Prior to checking the return-to-neutral function the
neutral must be adjusted correctly as detailed in
Neutral
Adjustment.
1. Drive the machine to a flat, level surface. Engage the
parking brake, disengage the PTO, turn the ignition switch
to OFF, and remove the ignition key.
2. Move both ground speed control levers into the operating
position, pull rearward, and then release.
3. After the ground speed control levers have stopped their
travel move the levers out towards the NEUTRAL
LOCKOUT position.
• If the levers align with the notches in the neutral lock
plate, no adjustment is necessary.
• If the levers do not align with the notches in the neutral
lock plate, adjustment is necessary. See your dealer.
Neutral Lockout Adjustment
Prior to adjusting the neutral lockout, the neutral and
return-to-neutral must be properly adjusted.
1. Park the unit on a flat, level surface such as a concrete
floor. Disengage the PTO, engage the parking brake, turn
the ignition switch to OFF, and remove the ignition key.
2. Chock the wheels of the unit to prevent movement.
36 snapperpro.com