SnapNrack Series 100 UL, Руководство по установке

Страница: 43 / 48

43
Series 100 UL
Rail Cutting Tool, and
End Cap
Design Tools
- SnapNrack has a suite of design tools
to help configure your PV installation to
be an accurate and fast install. Please
visit us at: www.SnapNrack.com.
Warning
- Always wear fall protection
and safety gear.
Notes
- SnapNrack engineered systems should
only be used with SnapNrack components
and hardware. Any alternate application
may void the warranty and structural
calculations could become invalid.
Rail Cutting Tool and
End Clamp
1) Slide the Cutting tool over the end of
the rail and place it so that the upper lip is
safely covering the edge of the module.
2) Use the reciprocating saw or band
saw to cut off the end of the rail.
3) Remove the cutting tool from the rail.
4) Insert SnapNrack rubber end cap
to have a flush finish to the array.
1) Slide Cutting Tool
over rail
3) Remove the Cutting
Tool
2) Cut off end of rail
4) Insert End Cap into
rail
Edge of array with end caps in rails