Snapmaker TH-L-P100-W450, Быстрый старт

Страница: 41 / 43

37 Quick Start Guide
The cotton swab is a single-use tool. If there is dust or grease remaining on the
laser lens protector after you wipe it once, take a new cotton swab and repeat step
to wipe the laser lens protector again.
After the 10W Laser Module has been used for a period of time, dust and grease may
accumulate on the laser lens protector, which will significantly decrease the engraving and
cutting capability of the laser. For this situation, you need to clean the laser lens protector to
recover the engraving and cutting capability.
Maintenance
Clean the Laser Lens Protector
Scenarios
How to Clean the Laser Lens Protector
Prepare the required clean tools: cotton swabs and ethyl alcohol.
Turn off the machine, and disassemble the 10W Laser Module from the machine.
Dampen a cotton swab with ethyl alcohol, and then stick it into the air concentrator hood
of the 10W Laser Module. Wipe the surface of the laser lens protector from center to margin
clockwise.
The clean work is done till no dust, grease, or water is on the surface of the laser lens
protector.
1
2
4
3
3