Snapmaker A350T, Быстрый старт

Страница: 39 / 51

70
|
Quick Start Guide
|
71
Laser Engraving and Cutting
4. Tap X- , X+ , Y- , or Y+ to move the laser dot to where the Work Origin will be, and then tap Set Work Origin and
Run Boundary to check if the work origin is proper. If not, reset the Work Origin and run boundary again.
5. Tap Start , and the machine will auto focus.
If the Laser Module runs into any portions of the machine, turn off the machine immediately.
Should you need to remeasure the focal length, refer to our online User Manual for detailed
instructions.
1. Remove the engraved material. Place a piece of blank white paper (no less than 150 mm x 150 mm) on the
center of the Laser Engraving/Cutting Platform, and fasten it.
4.2.2 Calibrate the Camera
Guides & Pictures / Snapmaker
2. Tap Start , and the machine will use the engraved square to calibrate the camera.
If you have detached the Laser Module from the X Axis, or if you have reassembled the
machine, please recalibrate the camera: Swipe left on the homepage of the Touchscreen ->
select
Settings -> tap Laser -> tap Camera Calibration .