Snap-On Zeus, Руководство пользователя

Страница: 232 / 235

Maintenance Screen Protector Installation
225
19.3 Screen Protector Installation
Touch screen protectors are available as optional equipment (contact your sales
representative to order). The following procedure describes typical installation
procedures.
Items recommended for installation:
•
Microfiber type cloth (lint-free)
•
Flexible straight edged tool (e.g. small squeegee, plastic card)
•
Cellophane tape
z
To install a screen protector:
NOTE
Cleanliness is the most important factor during the installation of the screen
protector. The following tips are provided to assist in the installation:
• Clean your hands thoroughly.
• Clean the touch screen thoroughly using a microfiber type cloth, removing all dirt,
dust, grease, fingerprints etc. See
Cleaning the Touch Screen on page 222
for
additional information.
• Work in a well lit area.
•
Minimize dust; work in an area with minimal air movement, turn off fans or air
conditioning etc.
1. Thoroughly clean and dry the touch screen. See
Cleaning the Diagnostic Tool
on page 222
for additional information.
2. Remove the rear mask (
Figure 19-3
) from the screen protector.
Figure 19-3
Removing rear mask
3. Carefully align the edge of the protector with the edge of the screen, and slowly
allow the screen protector to lie flat on the screen (
Figure 19-4
).
Figure 19-4
4. Once the protector is in place, use a microfiber cloth to work out any air
bubbles.
NOTES
To remove air bubbles, slowly work from the inside towards the edges. If large
air bubbles are trapped, it may be easier to carefully peel back the protector
and re-apply.
If air bubbles are persistent, it is an indication that the screen and/or protector
are not clean.
If visible dust is trapped under the protector, peel back the protector and use
the adhesive side of a small piece of cellophane tape to remove the dust.
1