Snap-On MIG160i, Инструкция по эксплуатации

Страница: 18 / 18

MIG1606
ALUMINUM TORCH INSTALLATION
1. Remove the steel welding wire and torch assembly if installed.
2. Remove the steel drive roller by loosening the set screw.
3. Remove the set screw and install into the aluminum drive roller (part number
CKS3080942). Install with the .035” U-groove toward the inside of the welder and Jghten
the set screw.
4. Remove the brass tube in the torch housing and
save. The tube needs to be installed when using all
other welding wire but aluminum.
5. Install the aluminum torch.
The liner sJck out should just stop just short of the drive roller.
6. Install the enclosed aluminum .035” wire and feed it into the guide tube and then into
the torch liner.
7. Close the drive arm and be careful
that the aluminum wire is aligned in the roller grove.
Very Important! Do not over increase the wire
roller tension with the tension knob. This will
cause the wire to “bird nest” between the roller
and the liner. The factory adjustment should be the correct tension exposing
approximately four rings.
8. Set the synergic curve for ALMG5 .035” 100% Argon.
9. Install the flow regulator to a tank of 100% Argon and adjust the flow to 40 CFH.
10. Set the material thickness and you are ready to weld.