Snap-On DESPERADO EELR319A, Инструкция по установке и эксплуатации

Страница: 7 / 18

7 of 18
5. INSTALLATION INSTRUCTIONS
5.1 UNPACKING PROCEDURE
Remove the metal strapping from the main structure package and slide the lift off the
shipping skid. Open the accessory box and check the contents of the box.
NOTE:
The Power Pack is already installed on the Power Pack Stand
5.2 HYDRAULIC SYSTEM INSTALLATION
1. Add 3 litres of ISO 32 (10 Hydraulic Weight) hydraulic oil to the power pack.
2. Reinstall the filler breather cap onto the power pack.
3. Plug the power pack utility cord into an approved 115 Volt outlet.
4. Install the 1/4” JIC female end of the 12’ long hydraulic hose to the outlet fitting on
the hydraulic cylinder.
5. Connect the other end (3/8"JIC female) of the 12' long hydraulic hose to the 90°
fitting on the power pack.
5.3 HYDRAULIC SYSTEM BLEEDING PROCEDURE
NOTE:
Make certain lift area is clear from debris and any obstructions.
1. Press the “UP” button on the power pack and raise the lift a few inches off the floor.
Check for any hydraulic leaks.
2. Lower the lift by pushing the down control lever on the power pack.
3. Lower the lift completely.
4. Repeat this procedure to bleed the hydraulic cylinder.
5. Raise the lift to engage the mechanical safety lock.
6. Lower the lift onto the safety.
7. Raise the lift a few inches to automatically disengage the mechanical safety.
8. Lower the lift completely.
9. Cycle the lift up and down completely a few times.
10. The hydraulic system is a self bleeding system.