Snap Fresh BBT-ZE20ST, Руководство пользователя

Страница: 13 / 20

.
.
Keep the line tight and clip the lines into the notches in the bottom flange of the spool to hold the
line in place while you fit the spool into the housing. The smaller end of the spring goes into the
top of the spool.
Then put the spool and spring into the housing leaving the ends of the line protruding from the cut
outs on each side.
.
Slide into place. Do the same on both sides.
.
Position the cover in place as shown and press the cover onto the housing until the clips snap
into place.
.
Pull on both ends of the line to free them from the notches in the spool.
.
To replace the spool, press on the spool lock button and screw the head clockwise onto the shaft
and hand tighten.
13
Step 3