SNAIGE C 14SM, Инструкция по эксплуатации

Страница: 5 / 12

4
INSTALLATION AND OPERATING CONDITIONS
Positioning:
•
This appliance can be installed in a dry, well ventilated indoor where the ambient
temperature corresponds to the climate class indicated on the rating plate of the
appliance.
Do not install this appliance in areas that are too humid or too colds, such as the
construction appendices, garages or wine cellars. Place the appliance away from
heat sources such as kitchen stove/oven, radiators, or direct sunlight. The appliance
must not touch any pipes for heating, gas or water supply, or any other electrical
devices.
Minimum distances from the heat sources:
- from the electric gas and other ovens - 30 mm,
- from oil or coal fired ovens - 300 mm,
- from built-in ovens - 50 mm
If there is no possibility of ensuring the above- mentioned
distances, provide an appropriate insulation board.
•
Do not cover the ventilation holes at the top of the appliances – it
must be a good air circulation around the appliance. There
should be a gap of at least 10 cm between the top of the
appliance body and any furniture that may be above it. If this
requirement is not followed, the appliance consumes more
electrical energy and its compressor may overheat.

•
The appliance must stand on a level surface and must not
touch the wall. If necessary, regulate the height of the
appliance by adjusting the levelling feet: by turning them
clockwise – the front of the appliance rises, by turning them
counter clockwise – it comes down. If the appliance is tilted
slightly backward – the doors will close by themselves.
•
If the appliance is placed in a corner, a gap must be left
between the appliance body and the wall.
Set-up dimensions (see fig. 8)

.
Preparing for operation:
It is recommended to prepare the appliance for operation with a
helper.
•
The unit should only be transported in its vertical position; do not tilt any more than 30°.
•
Remove package. Lift the appliance away from foamed polystyrene base. Tear off
adhesive tapes. Remove all red-coloured parts from the shelves (fig. 2.). When placing,
moving, lifting the appliance, do not hold the door handles, do not pull the
condenser at the rear part of the refrigerator and do not touch the compressor
unit.
•
The appliance should not be connected to the mains until all packing and
transport materials aren’t removed. Suitably dispose the packaging material.