Page
100
To make sure that the device is working properly, follow the three steps:
1. Verification of LEDs
2. Checking the device configuration (IP Settings)
3. Check the device logs (description below)
Verification of LEDs
Normal operation of the device is signaled by LEDs as follows:
LED
Correct operation
Power (PWR)
Continuously lit
User
Disabled
Ready (RDY)
Blinking
GSM
Slow flashing in stand-by mode, Quick flashing when modem in use
GPRS
Not used
Checking the device logs
SMSEagle operates on Linux system. Linux system log is available under menu position “Settings” > “Logs”.
In case of any problems with the device this log is a valuable source of troubleshooting information.
Please attach information from this log when contacting with SMSEagle Support Team.
When the device is not reachable
1.
Check if the device is correctly connected to the network. Check LED status of RJ45 socket.
2.
In the case when the device does not respond due to a malfunction or incorrect user settings
please reboot the device by disconnecting and connecting power source (or pressing Reset
switch).
3.
If you still cannot connect with the device, it is possible to restore to factory IP settings by using
the SW button.
Содержание NPE-9300-GPRS/3G
