®
BTD
6
USE AS DRIPPER
The positive pole screw, which is installed in the Taifun® BTD, has a channel through which the liquid is led to the coil.
Alternatively, this screw can also be replaced by a closed version (included in delivery). With this screw the Taifun®
BTD can also be used as a regular dripper.
First, the positive pole screw is unscrewed. Now the positive pole in the inside gets loose. If necessary, hold it with
one finger. Then the positive pole screw is replaced and screwed back in again. It fixes the positive pole inside. Make
sure that the positive pole sits correctly in the insulator and is not bent or twisted.
When changing the positive pole screw, there should be no coil in the device.
Unscrew the positive pole screw
Replace positive pole screw
Screw back again the positive
pole screw
8. CLEANING
Do not use cleaning agents as they could harm the o-rings.
Before assembling, check the completeness and positioning of the o-rings to prevent leakage of liquid.
• Disassemble the device into its components.
•
Do not
remove the PEI insert in the top cap..
• Clean the components (not the cotton) with warm water or in an ultrasonic bath.
• Completely dry the components before reassembling the device.
9. MAINTENANCE
• Wait until the device has completely cooled down before disassembling, to prevent burns.
• Make sure that there is no power supply by unscrewing the device from the mod or by switching off the mod.
