13
●
The LP Gas Cylinder must be a 20 pound cylinder and have a Type 1 Cylinder Valve Outlet
Connector.
●
Handle the Cylinder with care - do not drop it.
●
When you are not using the grill, the LP Gas Cylinder should be dis-
connected.
●
Connect the regulator and hand tighten firmly.
●
Do a leak test each time you connect a LP Gas Cylinder and before
lighting the grill.
●
Never use a match or lit flame to test for leaks.
●
To test, prepare a weak solution of detergent and water. Spray or
swab the solution onto the connection of the regulator to the LP Gas
Cylinder valve, and
on all the joints in the hose connections up to the burner valves (which
MUST be closed in the "OFF" position).
●
Open the LP Gas Cylinder valve, and watch for any
bubbles to appear at all the connection
points. No bubbles indicate - All Clear!
●
If there are any bubbles, there is a leak which must be fixed.
●
Never obstruct the flow of combustion and ventilation air.
Connecting the LP gas cylinder to the grill
Lighting the grill
●
Always open the Lid before lighting the grill.
●
All burner knobs should be in the "OFF" position.
●
Open the LP Gas Cylinder valve,1 – 1 1/2 turns.
●
Select one burner to light. Push and turn control knob to “LIGHT”
position.
●
Press the igniter button rapidly several times until the burner is lit.
●
You can then adjust the knob to your desired setting.
●
If the burner did not light, turn the knob back to the “OFF” posi-
tion, wait 5 minutes for any gas to clear away, and then repeat
the lighting procedure.
●
Follow same steps to light the other burners.
●
After using the grill, - turn all burner knobs to the "LIGHT" posi-
tion and then push fully in and turn to the "OFF" position.
●
At once turn the valve on the LP Gas Cylinder OFF.
●
IF the igniter does NOT light the burner, you can light
it with a match or a piece of burning paper, put it
through the openings in the Cooking Grid and next to
the Flame
Tent covering the burner. Then follow the
lighting procedure above.
●
Observe the proper burner flame - it should be a
blue/yellow color about 1/2” long.
OPERATING INSTRUCTIONS
YELLOW
BLUE
Burner
Good Flame
Bad Flame
