B-3
TM4400013
REV.
D
Your choice ?
<0 Enter > (Basic Configuration)
IP address: Enter new IP address
Set Gateway IP Address Default (N) <Enter>
Netmask: Enter Number of bits (enter 24 for A netmask, 16 for B netmask, or 8 for C netmask).
Change Telnet configuration password Default (N) <Enter>
To exit and save above entries, <9 Enter >
This completes the IP address setup, the Model 9100 is now ready for NTP.
Figure 1, NTS Physical Address Location (FSU)
IP Address Set-up, Second Method
ARP (Address Resolution Protocol) command is required to change address in this mode. This second method
of address setting should only be necessary if the factory default IP address is in use on the network, or a non-
valid IP address is loaded into the NTS engine by mistake or the address is not known.
To establish a Telnet session to the NTS, an IP address must be associated with the physical hardware.
Setting up a new IP address
.
(
Note: This procedure uses 10.1.5.250 as an example IP address and may differ
from that which the user is required to input)
1. Refer to Figure 1 for the location of the NTS physical address. This address appears on a label attached
to the NTS engine, located on the Model 9104 FSU (Figure 1).
2. From a DOS prompt in the c:\windows directory type:
FSU
XX.XX.XX.XX.XX.XX
NTS Engine
NTS Physical Address
Содержание TRAK 9100
