Issue 001 - November 2018 | SmithsEP.co.uk | 21
Temperature control for Comfort
(COMF) and Temperature control
for Setback (SETB) enabled
How to operate – Run back Timer
mode enabled
SS3E
1. Ensure your fused spur is switched ON.
2. Ensure the wireless controller is switched ON
3. Switch the upper fan switch to ON.
4. Ensure the wireless controller is paired (page 9)
with the heater
5. Set the thermostat to the desired temperature
up to the maximum set during the
installation process
6. Set the left hand switch to ON (switch
illuminates)
A. If you require a faster warm up, set the
right hand switch only (switch illuminates)
B. For 3 kW press both switches
(switches illuminate)
8. If the temperature falls below the minimum
temperature set (SETB) during installation the
heater will switch ON automatically
9. To turn the heater OFF, set the wireless
controller switch to off (heating symbol not
shown on display)
For your safety this Kitchen Heater is fitted with
an automatic overheat protection. If the heater
stops, turn off the power at the fused spur, wait 5
minutes and switch the power back on.
600
586
380
86
97
165
60
110
9
110
1kW
2kW
3kW
1. Ensure your fused spur is switched ON
2. Ensure the wireless controller is switched ON
3. Switch the upper fan switch to ON
4. Ensure the wireless controller is paired (page 9)
with the heater
5. Set the thermostat to the desired temperature
6. Set the left hand switch to on1kW to ON
(switch illuminates)
A. If you require a faster warm up, for
2kW set the right hand switch only to ON
(switch illuminates)
B. For 3kW heat output press both switches
(switches illuminate)
7. Press the wireless controller ON switch up to
four times. The display will indicate the
running time of the heater. If the heater
reaches the desired temperature during the
running time, it will switch off.
8. To turn the heater OFF, set the controller
switch to off (heating symbol not shown on
display). Press the controller ON switch up to
four times.
600
586
380
86
97
165
60
110
9
110
1kW
2kW
3kW
