10 | SmithsEP.co.uk | Issue 001 - November 2018
1. Before switching the heater on, please ensure
the fascia grille is free from obstruction
2. Ensure your fused spur is switched ON
3. Ensure the heater is paired with the wireless
controller
4. Ensure the controller is switched on and
calling for heat
5. Set the upper fan switch and the middle
1kW switch to ON
6. If you require a faster warm up, set the lower
2kW switch to ON. Please note all switches
must be in the ON position to achieve
2kW output
7. To turn the heater OFF, set the controller
switch to OFF (heating symbol not shown
on display)
For your safety this Space Saver heater is fitted
with an automatic overheat protection. If the
heater stops, turn off the power at the fused spur,
wait 5 minutes and switch the power back on.
Commissioning
Fan on
1Kw on
2Kw on
Off
Off
Off
OFF
OFF
OFF
FAN ON
1KW ON
2KW ON
SS2E
SS3E
1. Before switching the heater on, please ensure
the fascia grille is free from obstruction
2. Ensure your fused spur is switched ON
3. Ensure the heater is paired with the wireless
controller
4. Ensure the controller is switched on and
calling for heat
5. A. For 1kW heat output press left hand switch
only (switch illuminates)
B. For 2kW heat output press right hand
switch only (switch illuminates)
C. For 3kW heat output press both switches
(switches illuminates)
6. To turn the heater OFF set the controller
switch to OFF (heating symbol not shown
on display)
Space Saver is fitted with an electronic safety (ES)
control which is a safety device which switches
off the heater, if for any reason, the appliance
overheats. The ES controls can only be reset after
the appliance has cooled down in order to reset
the ES control see fault finding.
600
586
380
86
97
165
60
110
9
110
1kW
2kW
3kW
