Smithco Spray Star 1750 Series, Запчасти и обслуживание

Страница: 97 / 104

95
Accessories
15-619 CHEMICAL CLEAN-LOAD INSTALLATION INSTRUCTIONS
1. Make sure sprayer tank is empty and flush all chemical residue from sprayer. Always wear protective
clothing, goggles and gloves.
2. Remove plug from tee on spray pump (Ref A).
3. Install one of the 90° fittings (Ref 2), should point to the back of the machine.
4. Install 88" of 1
1
/
4
" discharge hose (Ref 4) onto the elbow on the pump that points back and tighten hose
clamp (Ref 3).
5. Route the 88" hose to the back of the sprayer so it connects over the top of the left boom support tube.
6. Mixer Mount (Ref 8) is already installed on boom center post.
7. Mount Clean-load Assembly (Ref 5) onto mixer mount using
5
/
16
x
3
/
4
flange Hex Bolts and flange nuts.
Tighten.
8. Install 18-391 reducer coupling (Ref 4) onto outlet side. Then a 16-156 90° elbow (Ref 2) into the cou-
pling pointing up and one into valve with yellow handle. Tighten fittings so that the elbow in the valve is
pointing up and forward. The outlet fitting should be pointing up.
9. Remove the plug from the top back of the spray tank and install 16-972 45° fitting (Ref 9) and 16-159
hose barb (Ref 10) and tighten.
10. Install the loom clamp mount (Ref 12) and the loom clamp (Ref 11) onto the center boom, using the
5
/
16
x 1 Hex Bolt and Nylon Lock Nut.
11. Now the 31" hose (Ref 1) can be installed from the tank to the outlet fitting through the loom clamp.
Tighten with hose clamps .
12. The hose from the spray pump can be connected to the inlet fitting and tightened with hose clamps.
13. Make sure all hardware, fittings and clamps are tight. Add about 25 gallons of water to the spray tank.
Start sprayer and circulate water through system to check for leaks.
14. Be sure to read start up, loading and shutdown instructions for Clean-load Assembly before using with
chemicals. When working with chemicals Always wear protective clothing, goggles and gloves.
TROUBLE SHOOTING