EN
9
Warning!
This operation must be carried out with care to prevent the washer-
dryer from vibrating, moving or generating excessive noise during use.
If the appliance is installed on a carpeted floor, take care to ensure
that the openings in the bottom of the washer-dryer are not obstructed.
Also check that during operation the washer-dryer is not resting against
walls, kitchen units, etc.
The appliance must not be installed behind a door with lock, a sliding door, or
a door with hinge on the opposite side.
2.3 CONNECTING TO THE WATER SUPPLY
1. Check that the water supply pressure is in the follow-
ing range:
0,05-0,9MPa
. With higher pressures, use a
pressure reducer.
2. Connect the
cold water
supply hose (
blue
screw
collar) to the cold water tap with ¾ gas threaded con-
nector, taking care to tighten firmly to prevent leaks.
The water supply hose must not be kinked or crushed
and must not be changed or cut. Threaded connections
must only be tightened by hand.
3. When appliances are supplied with
hot water
, the intake water temperature
must not exceed 60°C and the hose with
red
screw collar must be connected
to the hot water supply tap.
Warning!
If the connection is made to new pipelines, or lines which have been out
of use for a long time, allow a considerable amount of water to flow out be-
fore connecting the intake hose. This prevents any sand or other dirt from
fouling the filters installed in the appliance to protect the water intake valves.
The new intake hose supplied with the appliance must be used, and the old
water supply hose must not be used.
Supplementary note regarding the water connection for the German mar-
ket.
Before connecting the product to the water supply, make sure that the water
system has been fitted with a safety device to protect drinking water against
contamination due to backflow (according to DIN EN 1717). The water valves
and/or taps are fitted with these safety devices if the water system of the house
has been properly implemented.
