29
Instructions for the installer
Make the connection to the gas mains using a rubber hose whose specifications
comply with current standards (verify that the reference standard is stamped on the
hose).
Carefully screw the hose connector
3
to the appliance’s gas connector
1
(1/2”
thread ISO 228-1), placing the seal
2
between them. After having tightened the
hose connector, push the gas hose
5
onto the hose connector and secure it with the
clamp
4
that is compliant with the standard in force.
10.3.2Connection with a flexible steel hose
WARNING: The following instructions are valid for all types of installation, see fig. A, B, C in
chapter “10.1 Installing in kitchen units”.
Only use standards-compliant continuous wall steel hoses no longer than 2 metres.
This type of installation can be used for both built-in and free-standing appliances.
Make the connection to the gas mains using a continuous wall flexible steel hose
whose specifications comply with the applicable standard.
Carefully screw the connector
3
to the appliance’s gas connector
1
(1/2” thread ISO
228-1), placing the seal
2
between them.
10.3.3Connection with a flexible steel hose with conical fitting (where present)
WARNING: The following instructions are valid for all types of installation, see fig. A, B, C in
chapter “10.1 Installing in kitchen units”.
Only use standards-compliant continuous wall steel hoses no longer than 2 metres.
This type of installation can be used for both built-in and free-standing appliances.
Make the connection to the gas mains using a continuous wall flexible steel hose
whose specifications comply with the applicable standard.
Carefully screw the connector 3 to the appliance’s gas connector 1 (½” thread ISO
228-1), placing the seal 2 between them. Apply insulating material to the thread of
the connector 3, and then tighten the flexible steel hose 4 to the connector 3.
2
1
3
2
1
4
3
