Instructions for the installer
20
6. FINAL OPERATIONS
Having carried out the above adjustments, reassemble the appliance following, backwards, the
instructions in paragraph "5.1 Removing the hob".
6.1 Regulation of minimum for natural gas
Replace the components on the burner and slide the knobs on the gas tap
pins. Light the burner and set it at minimum position. Remove the knob and
turn the regulation screw inside or next to the gas tap pin (depending on the
model) until you get a suitable minimum flame. Replace the knob and check
burner flame stability: (rapidly turning the knob from maximum to minimum
position, the flame should not go out).
6.2 Regulation of minimum for LPG
To regulate the minimum for LPG, completely tighten (clockwise) the screw inside or next to the gas tap
pin (depending on the model).
The diameters of the by-passes for each burner are given in table "5.2 Regulation for LPG".
After having regulated the device with a gas other than the one tested, replace the label located on the
bottom enclosure with the one that corresponds to the new gas. The label is inside the bag that contains
the nozzles.
6.3 Arrangement of burners on hob
Burners
2. Semirapid
3. Rapid
6. Double crown
6.4 Lubrication of gas taps
After a while, the gas tap may become hard to turn or lock. If this happens, it has to be cleaned inside
and re-greased.
This must be done by a qualified technician.
6
6
2
6
3
