Smeg LB86, Инструкция по эксплуатации

Страница: 16 / 32

150241
150241
When adding softener, be careful to fill the
dispenser only up to the marked level.
Be sure to close the detergent dispenser
when opening/closing the appliance door.
•
Push the START button (F). Sound signal
confirms the start, the LED indicating particular
washing stages stops flashing. The machine
starts operating after a few seconds. If the door
is not properly closed after starting the operation,
the washing stage indicator LED starts flashing
again after a few seconds. When you close the
door, the machine initiates the selected program.
•
As each washing stage is completed the relevant
washing stage indicator LED goes off and the
subsequent one goes on.
•
In case you would like to alter the washing
program after the initiated washing operation,
turn the program selector for one second to the
position “0”, followed by the selection of a new
program. Switching the machine off deletes any
previously selected additional functions(i.e. Pump
stop), so they have to be reactivated.
Upon switching OFF, all additional pre-
selected functions are deleted; therefore
they must be switched-ON again.
If a power failure occurs during the
washing program, when the power is
restored the machine will resume the
execution of a program where it had been
interrupted.
- End of operation
Flashing LED’s for particular washing stages
indicate that the program was completed.
•
Sound signal indicates that you may now open
the door of the machine.
•
Extract the laundry from the drum and remove
16
17
Start the operation