Smeg HTY511DH, Оригинальное руководство пользователя

Страница: 30 / 36

30
10 CHOSING THE PROGRAM
Scrolling through the programs available displays first the program name (in English) and hen the number
(P1, P2….. etc.) followed by the duration.
PROGRAM TYPE OF DIRT DURATION (*)
DISHES Short P1 Lightly soiled plates 1 min
DISHES Long P2 Heavily soiled plates 2 min
TRAYS P3 To wash pans and trays 3 min
POTS P4 Pots and pans 4 min 10s
CUTLERY P5 Intensive programm with 70°C washing 7 min 10s
USER PR P6 Customisable (see "set-up information") 1- 10 min
(*) The cycle duration stated above is guaranteed if the water intake temperature is as stated and recommended in the
"TECHNICAL DATA" table, and in all cases refers to the first cycle performed. For repeated cycles, operating conditions may vary
from installation to installation. If the dishwasher is supplied with cold water, the cycle duration might increase depending on
the intake water temperature and the "thermostop" setting.
Power blackouts.
If the dishwasher is open when power is restored, the display will read “
° t
” and the heating
element will remain off, to prevent the risk of burns to the user.
Close the dishwasher to resume heating the water in the tank.
ENABLING/DISABLING THE PROGRAM NAME ON THE DISPLAY
The display shows the program number P1, P2, P3 and name, Glass, Dishes, Cutlery etc. by default. You can
choose not to display the name of the program. In this case, only P1, P2, P3 etc. will be shown on the
display.
The procedure must be carried out with the machine switched off but powered.
Press and hold down the start / pause button.
When the vertical lines ||||| appear on the display, release the start / pause button and then press it
again immediately.
The procedure is complete; there is no audible or visual confirmation.
It is possible to check if the procedure has been carried out correctly when the machine is switched on again.