19
7.1
SET-UP (
Authorised staff only
)
Dishwasher parameter modification procedure
With the tank empty
1- Switch the appliance on; the display will show “FILL” and
filling will start.
2- Open the door/lift the hood (depending on the model);
"CLOSE" will appear on the display
3- Press the
button and hold it down for 5/7 seconds.
When -------- appears on the display, release the button and
press it again to access the main PCB setup menu.
With the tank full/the hood open
1 - Press the
button and hold it down for 5/7 seconds.
When -------- appears on the display, release the
button
and press it again to access the main PCB setup menu.
All the modifiable parameters can now be displayed, scrolling through them with the
button.
Press the
button to select the value required for each parameter.
To confirm the value required simply quit the menu or move on to the next parameter by pressing
.
Quitting the setup menu automatically:
wait
about 3 minutes
without using the controls.
Quitting the setup menu in manual mode:
hold the
ON/OFF
button until the
beep
sounds; the
dishwasher switches off.
7.2
Modifiable parameters
The illustrations are purely guideline. The minimum and maximum temperatures available depend on the
model (glass washer, dishwasher, undercounter or hood-type model, ..).
Rinsing temperature
(boiler temperature)
Washing temperature
(tank temperature)
Warning:
The tank and boiler temperatures shown on the display may be different from the actual
temperatures by a few degrees, especially in transient phases (just after the FILL is completed, just after
the end of the cycle, etc.) due to the inertia of the measurement probe.
Set-up
During first start-up, the functions/parameters listed below must be set or adjusted:
Содержание HTY511DH
Страница 13: ...13...
