Maintenance and cleaning
21
11.MAINTENANCE AND CLEANING
DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE ANY PROCEDURE THAT REQUIRES
ACCESS TO LIVE PARTS.
The Home Garden requires very simple periodic maintenance and cleaning; if done regularly, it will be
keep in excellent operating and aesthetic condition.
11.1 Filling the tank
The Home Garden’s tank is empty when purchased. It must be filled in order for the appliance to
operate.
It is best to fill the tank only after having positioned the Home Garden.
The tank water level can be seen through the front window, under the control panel.
When the level falls below a certain value, the
symbol on the control panel will start flashing. When
this symbol is flashing, the humidifier is not able to generate vapour and the tank must be filled as
follows.
WHEN THE
SYMBOL STARTS FLASHING, SOME AMOUNT OF WATER IS STILL LEFT IN THE
TANK, BUT IT CANNOT BE USED.
Extract the sliding trays and pots as described in paragraph "10.1 Removing and placing the pots in the
Home Garden". With the trays and pots extracted, remove cap “
A
” by lifting it off as shown in the figure.
Use a garden watering can to slowly fill the tank through hole “
B
”. A float inside the tank slowly rises as
the water level increases and indicates when the tank is full .
Always check that the water level does not exceed the “max” mark on the
front of the tank.
Once the tank is full, close the cap, refit the pots, slide the trays back in and lower the side panels.
AFTER FILLING THE TANK, PRESS THE
KEY ON THE REMOTE CONTROL TO SWITCH OFF
THE FLASHING SYMBOL ON THE CONTROL PANEL AND RETURN TO NORMAL OPERATION.
(Fig. 10)
