Smeg DWAFI4510, Инструкция по эксплуатации

Страница: 30 / 32

User instructions
28
6. Troubleshooting
The dishwasher is capable of signalling a number of faults by the
simultaneous illumination of multiple indicator lights; the meanings are given
below:
FAULT DESCRIPTION
E1
Aquastop failure
The anti-flooding system has activated (relevant
models only). The system trips in case of water leaks.
Contact the after-sales service.
E2
Safety level
The system which limits the water level inside the
dishwasher has tripped. Interrupt the program and
switch off the dishwasher. Switch the dishwasher
back on, program it again and start the wash cycle. If
the problem persists, contact the after-sales service.
E3
Water heating malfunction
Water heating is not operating or operating
incorrectly. Repeat the wash program; if the problem
persists, contact the after-sales service.
E4
Water temperature monitoring malfunction
Interrupt the program and switch off the dishwasher.
Switch the dishwasher back on, program it again and
start the wash cycle. If the problem persists, contact
the after-sales service.
E5
Water intake malfunction
The appliance is not taking in water or is not doing so
correctly. Check that the water connections are
correct, the water supply tap is turned on and the
filter is not clogged. If the problem persists, contact
the after-sales service.
E6
Water pump-out malfunction
The appliance is not pumping out the water or is not
doing so correctly. Check that the drain hose is not
kinked or crushed and that the trap or filters are not
clogged. If the problem persists, contact the after-
sales service.