Stulz Driver Manual
Page 7 of 16
CONFIGURING THE FIELDSERVER AS A STULZ CLIENT
For detailed information on FieldServer configuration, refer to the FieldServer Configuration Manual. The
information that follows describes how to expand upon the factory defaults provided in the configuration
files included with the FieldServer (s
ee “.csv” files provided with the FieldServer).
This section documents and describes the parameters necessary for configuring the FieldServer to
communicate with a Stulz microcontroller device.
The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order to
enable the FieldServer for Stulz communications, the driver independent FieldServer buffers need to be
declared in the “Data Arrays” section, the FieldServer virtual node(s) needs to be declared in the “Nodes”
section, and the data to be provided to the Clients
’ needs to be mapped in the “Map Descriptors” section.
Details on how to do this can be found below.
NOTE: In the tables below, * indicates an optional parameter, with the bold legal value as default.
4.1
Client Side Connection Parameters
Section Title
Connections
Column Title
Function
Legal Values
Port
Specify which port the device is connected
to the FieldServer.
R1-R2
1
Protocol
Specify protocol used.
Stulz
Baud*
Specify baud rate.
9600
– The baud rate is limited by the
Stulz bus being only 9600
Parity*
Specify parity.
None
Data_Bits*
Specify data bits.
8
Stop_Bits*
Specify stop bits.
1
Poll_Delay*
Time between internal polls.
0-32000 seconds,
0.05 seconds
Example
// Client Side Connections
Connections
Port , Protocol , Baud , Parity
, Poll_Delay
R1
, STULZ
, 9600
, None
, 0.100s
1
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction manual for details of the ports
available on specific hardware.
