SMC Networks SY 5000 Series: SY7000 Series, Руководство по эксплуатации

Страница: 12 / 36

SY3000*-OMJ0003-A
-11-
ＳＹ
ＳＹ ＳＹ
ＳＹ Ｓｅｒｉｅｓ
Ｓｅｒｉｅｓ Ｓｅｒｉｅｓ
Ｓｅｒｉｅｓ
ＳＹ
ＳＹ ＳＹ
ＳＹ３０００
３０００ ３０００
３０００・
・ ・
・５０００
５０００ ５０００
５０００・
・ ・
・７０００
７０００ ７０００
７０００ Ｓｅｒｉｅｓ
Ｓｅｒｉｅｓ Ｓｅｒｉｅｓ
Ｓｅｒｉｅｓ
Specific Product Precautions 4
Be sure to read before handing.
Connection
1.Loosen the holding screw and pull the connector out of the solenoid
valve terminal block.
2.After removing the holding screw, insert a flat head screwdriver, etc.
into the notch on the bottom of the terminal block and pry it open,
separating the terminal block and the housing.
3.Loosen the terminal screws( slotted screws) on the terminals block,
insert the cores of the lead wires into the terminals according to the
connection method, and fasten them securely with the terminal
screws.
4.Secure the cord by fastening the ground nut.
Changing the entry direction
After separating the terminal block and housing, the cord entry can be
changed by attaching the housing in the desired direction (4 directions
at 90
°
intervals)
*When equipped with a light, be careful not to damage the light with the
cord’s lead wires.
Plug Connector Lead Wire Length How to Use DIN Terminal
Standard length is 300mm, but the following lengths are also availabe.
When making connections, take note that using other than the
supported size (
φ
3.5 to
φ
7) heavy duty cord will not satisfy IP65
(encloure) standards. Also, be sure to tighten the ground nut and
holding screw within their specified torque ranges.
Caution
Precautions
Plug in and pull out the connector verically without tilting to one side.
Compatible cable
Cord O.D.:
φ
3.5 to
φ
7
(Reference) 0.5mm
2
, 2-core or 3-core, equivalent to JIS C 3306
Caution
Caution