SMC Networks SMCWEB-N2, Руководство пользователя

Страница: 23 / 148

SMCWEB-N2 Wireless N Universal Repeater User Manual
- 23 -
Interface/Button Description
WAN/LAN If SMCWEB-N2 is set to the AP mode, the interface is a
WAN interface which connects SMCWEB-N2 to WAN or
uplink network devices.
If SMCWEB-N2 is set to the Repeater/Client mode, the
interface is an LAN interface.
Reset Press the Reset button gently for 3-6 seconds and then
release it. The system restores to the factory default
settings.
AP/Repeater/Client It is used for setting SMCWEB-N2 to the AP, Repeater,
or Client mode.
AP mode—including the Bridge and router modes
Repeater mode—to expand wireless network coverage
Client mode—equivalent to a wireless network adapter
WPS For enabling WPS PBC mode. For more information,
refer to WPS descriptions for each mode.
4.2 Hardware Installation
4.2.1 System Requirements
Before installing the device, please ensure that the following items are available:

At least one Ethernet RJ45 cable (10BASE-T/100BASE-T)

One SMCWEB-N2 Wireless N Universal Repeater

A PC is already installed with the TCP/IP protocol and the PC can access
the Internet.
4.2.2 Before You Begin
Before you install the device, please pay attention to the following items:

The Ethernet cables that are used to connect the device to a computer, hub,
router, or switch should be less than 100 meters.

Do not place this device on an uneven or unstable surface. Do not put this
device on the ground.

Keep the device clean. Prevent the device from direct sunlight. Avoid any
metal in the device.

Place the device in the center of the area to optimize the wireless coverage.