HRX-OM-J022
3 Transport and Installation
HRG001-W HRG002-W HRG005-W
3.1 Transport
1
st
edition :Jul. 2005
3-1
3. Transport and Installation
3.1 Transport
The unit is heavy and poses potential danger at transportation. To prevent
damage to the unit, be sure to follow the instructions below when
transporting the unit.
The unit must be handled in correct manner.
Exercise caution to assure personnel safety during the installation,
operation, maintenance, and inspection of the unit.
Only personnel with sufficient knowledge and experiences with the
unit and system are allowed to transport, install and conduct
maintenance possibly exposed to dangerous situations.
z
If eyebolts are used for lifting, ensure the unit is held at four points.
z
Keep each eyebolt at an angle from 45 to 60 degrees with repect to
the postion of the center of gravity when lifting the unit.
If the forklift is used for transporting, ensure that the fork is inserted in
a place as specified in Fig. 3-1 “Fork insertion position and unit
lifting ”.
Never set the unit on its side.
The refrigerant oil will drain into refrigerant piping from the
compressor, reducing its amount in the compressor. It results in a
compressor failure.
Drain the residual fluid from the piping as much as possible to prevent
spill.
If the forklift is used for transporting the unit, be sure to prevent the
fork from contacting the cover panel or pipe connection ports.
