11 / 13
FGX-OM-N027-B
①
Remove the basket by
lifting it vertically. (Figure on the right)
②
Check O-ring mounted to the holder in the case. If there is any failure such as
swelling, replace O-ring with a new one.
[Assembly part number of the holder for replacement]
Part no.: FGF-KT03 (For FGFS1
□
: Seal material NBR)
Part no.: FGF-KT04 (For FGFL1
□
: Seal material FKM)
*Set of holder and O-ring.
Caution Be careful not to burn your skin if the temperature is high.
3
[How to remove element]
①
The element has a handle made of cloth. Move the handle to the center with your
finger or a bar to pull the element out of the basket.
[Element for replacement]
Part no.: EJ501S-
※
(For FGF
□
1A: Element size Ø190 x L440)
Part no.: EJ601S-
※
(For FGF
□
1B: Element size Ø190 x L770)
Nominal filtration symbol
※
is the space for the symbol of filtration.
Check the element part number on the model number label before ordering.
(e.g ) Nominal filtration 5mm : EJ501S-005
Caution Be careful not to burn your skin if the temperature is high.
4
[How to mount the element]
①
Pull the cloth handle of a new element to the center. Squeeze the element brim to
insert the element into the basket. Then, put the element brim down to the level
of the bottom flange of the basket.
②
Put back the basket handle in the vertical direction.
③
Hold the handle to install the basket in the case.
④
Set the handle in a position which does not interfere with either “IN” side or “Latch”
(slanted by 45 degrees)
5
[Mounting of the cover]
①
Set O-ring to the case.
②
Mount the tube gasket to the cover.
Rotate the cover clockwise pushing down to the end so that the positioning mark
for the cover and the case meet. (Figure
②
on the right)
6
[Mounting and tightening of V band]
Fig. A Mounting of V band (Correct) Fig. B Mounting of V band
(Incorrect, not horizontal)
①
Mount V band.
①
-1 Mount V band to the brim of the cover and the case.(Fig. A, B)
Cloth handle
Element
Handle
Basket
Latch
②③④
Cross section
of B
Case
Holder
“
Ｏ
” ring
①
Element brim
Positioning
mark
on the case
②
Positioning mark
on the cover
○
O-ring
Case brim
Retainer
Cover brim
×
