SMC Networks EX250-IE1, Руководство по эксплуатации

Страница: 19 / 24

-18-
No.EX
※※
-OME0004-E
Display/Setting
○LED Display
EX250-IE1 EX250-IE2/IE3
LED display Description
PWR
ON Power supply for sensor is ON.
OFF Power supply for sensor is OFF.
0, 1, 2, 3
ON Sensor signal input corresponding to the number is ON. (Logic "1")
OFF Sensor signal input corresponding to the number is OFF. (Logic "0")
○Switch setting

Applicable sensor to the Input Block can be switched to NPN/PNP.

Remove the input block, then set up the switch with a sharp-pointed watchmakers screw driver etc.

Install the input block after the setting.

For the Mounting/Removal of the input block, refer to page 9 .

The default switch setting of the product is PNP.
NOTE
Be sure to disconnect the power supply before setting the switch.
Slide the switch to the PNP or NPN position completely.
Otherwise, the input block may be damaged.