R
ATE
L
IMIT
C
OMMANDS
4-191
rate-limit
This command defines the rate limit for a specific interface. Use this
command without specifying a rate to restore the default rate. Use the
no
form to restore the default status of disabled.
Syntax
rate-limit
{
input
|
output
} [
rate
]
no rate-limit
{
input
|
output
}
•
input
– Input rate
•
output
– Output rate
•
rate –
Maximum value in Mbps. (Range: 1 to 1000 Mbps)
Default Setting
1000 Mbps
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 600
Console(config-if)#
Содержание 8700S-130
