SMC Networks 6624FMST, Руководство по управлению

Страница: 232 / 388

9-42
Configuring Advanced Features
Stack Management
Co
nf
ig
u
ri
ng Adva
nce
d
Feat
u
res
You would then execute this command in the “North Sea” switch’s CLI to
remove the switch from the stack:
North Sea(config)# no stack join 0030c1-7fec40
Using the CLI To Access Member Switches for Configuration
Changes and Traffic Monitoring
After a Candidate becomes a Member, you can use the telnet command from
the Commander to access the Member’s CLI or console interface for the same
configuration and monitoring that you would do through a Telnet or direct-
connect access from a terminal.
Syntax: telnet <switch-number>
where: unsigned integer is the switch number (
SN
) assigned by the Com-
mander to each member (range: 1 - 15 ).
To find the switch number for the Member you want to access, execute the
show stack view
command in the Commander’s CLI. For example, suppose that
you wanted to configure a port trunk on the switch named “North Sea” in the
stack named “Big_Waters”. Do do so you would go to the CLI for the
“Big_Waters” Commander and execute show stack view to find the switch
number for the “North Sea” switch:
Figure 9-36. Example of a Stack Showing Switch Number (SN) Assignments
To access the “North Sea” console, you would then execute the following telnet
command:
SMC6624M(config)# telnet 3
You would then see the CLI prompt for the “North Sea” switch, allowing you
to configure or monitor the switch as if you were directly connected to the
console.
SMC6624M(config)# show stack view
Stack Members
SN MAC Address System Name Device Type Status
-- ------------- ---------------- ----------- -------------------------
0
0030c1-7fec40 SMC6624M SMC 10/100 Commander Up
1 0060b0-880a80 Indian Ocean SMC 10/100 Member Up
2 0060b0-df1a00 Bering Sea SMC 10/100 Member Up
3 0030c1-7fc700 North Sea SMC 10/100 Member Up
The switch number
(
SN ) for the “North
Sea” switch is “ 3 ”.