Advanced Configuration
6-29
•
Enable: Wireless bridge filters Ethernet protocol types based
on the configuration of protocol types in the filter table. If a
protocol has its status set to “ON,” the protocol is filtered from
the wireless bridge.
CLI Commands for VLAN Support
– From the global
configuration mode use the
native-vlanid
command to set the
default VLAN ID for the Ethernet interface, then enable VLANs
using the
vlan enable
command. When you change the access
point’s VLAN support setting, you must reboot the access point to
implement the change. To view the current VLAN settings, use
the
show system
command.
CLI Commands for Bridge Filtering
– Use the
filter ap-manage
command to restrict management access from wireless clients.
To configure Ethernet protocol filtering, use the
filter
ethernet-type enable
command to enable filtering and the
filter
ethernet-type protocol
command to define the protocols that
AP(config)#native-vlanid 3
7-125
AP(config)#vlan enable
7-124
Reboot system now? <y/n>: y
Содержание 2888W-M
