![background image](http://html.mh-extra.com/html/smc-networks/2888w-m/2888w-m_owners-manual_1300139060.webp)
Hardware Installation
4-8
Note:
The wireless bridge’s Ethernet port does not support Power over
Ethernet (PoE) based on the IEEE 802.3af standard. Do not try to
power the unit by connecting it directly to a network switch that
provides IEEE 802.3af PoE. Always connect the unit to the
included power injector module.
1.
Connect the Ethernet cable from the wireless bridge to the
RJ-45 port labeled “Output” on the power injector.
2.
Connect a straight-through unshielded twisted-pair (UTP)
cable from a local LAN switch to the RJ-45 port labeled
“Input” on the power injector. Use Category 5 or better UTP
cable for 10/100BASE-TX connections.
Note:
The RJ-45 port on the power injector is an MDI port. If connecting
directly to a computer for testing the link, use a crossover cable.
3.
Insert the power cable plug directly into the standard AC
receptacle on the power injector.
4.
Plug the other end of the power cable into a grounded, 3-pin
socket, AC power source.
Note:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
Input
Output
Ethernet cable
from LAN switch
Ethernet cable to
wireless bridge
AC power
Power LED indicator
Содержание 2888W-M
