www.smartwitness.com
Secure the KP1S to the windscreen behind the rear view mirror, below the A1 line.
The camera lens
should be as high on the windshield as possible, but still within the windshield wiper zone.
4.
KP1S Power Adaptor and Wiring:
To connect the KP1S lead cable to the INT1S power adaptor, lining up the arrows on the silver cable
connectors and then push together. Twist the silver plate as shown below to secure the connection.
After Connecting the INT1S power cable to the KP1S power lead, lay out the power cable roughly
where it will run once hidden behind the vehicle's interior panels. This gives you an idea of where to
route the cable and how much slack to leave on the way down to the vehicle’s power source.
Secure the power cable extension into the headliner and down the A-Pillar. Route the power cable
around the side and behind the rest of the interior panels down towards the fuse box / power
source. Make sure the vehicle is off and then connect the required wires to the vehicle, as shown
below in the wiring diagram.
IMPORTANT:
Make sure that the glass is clean and dry before attaching. Hold the camera in
position with firm pressure for 30 seconds. The glass temperature should not be too hot or cold.
Please install in moderate temperature (recommended between 50°F ~ 80°F)
Power Cable to KP1S
Power Adaptor
Wiring Harness to
Vehicle
