SmartSafe iSmartIMMO 801, Руководство пользователя, Страница: 13 / 48

iSmartIMMO 801 User Manual
l
9
side for most vehicles. For some vehicles with special designs, the DLC
location may vary.
If the DLC cannot be found, refer to the vehicle’s service manual for the
location.
4.2.2
Vehicle Connection
Follow t he steps mentioned below to connect OBD II vehicle:
1. Locate the vehicle’s DLC socket.
2. Plug the VCI dongle into the vehicle’s DLC socket (It is suggested to use the
OBD II extens ion cable to connect the VCI dongle and DLC socket).
For non-OBD II vehicle, please proceed as follows:
1.
Select the corresponding adaptor/cable according to the vehicle’s DLC type.
2. Plug the non-16pin end of the adaptor cable into the vehicle’s DLC port, then
connect the other end to the OBD I adaptor, and then tighten the captive screws.
3. Connect the other end of the OBD I adaptor to the diagnostic cable.
Note: If the pin of the DLC is damaged or the DLC has insufficient power, you can get
power via the Cigarette Lighter Cable: Plug one end of the cable to the vehicle’s
cigarette lighter receptacle, and other end to the DC port of the OBD I adaptor.
4.3 Communication Setup
There are 2 ways available for the tablet to communicate with the VCI dongle:
BT(wireless) communication and USB cable connection. User can choose either of
the following ways to establish communication.
4.3.1 Pairing up via Wireless (BT) Communication
After the sign-up is successfully completed, the Bluetooth communication
between the tablet and the VCI dongle is automatically established and user has
no need to configure it again.
4.3.2
USB Cable Connection
1. Connect one end of the data cable (optional) to the Data transmission port of
the VCI dongle.
2. Connect the other end to the USB expansion slot of the tablet. The power LED
of the VCI dongle will light up.
Note: The USB connection provides the most stable and fastest communication.
When both the communication methods are applied at the same time, the tablet will use
the USB communication as the default priority.
5 Immobilizer Operations
5.1 Anti-theft matching