19 20
Troubleshooting suggestions
·
If the peripherals are working normally,
but the problem is not resolved
,
Please re-
initialize the device and run the device
calibration again.
2
3
A.W.C. fault
A.W.C. fault
1
A.T.O. fault
4
·
It is usually caused by the failure of the
water source or water inlet and outlet
components. Please check the water source
and observe the water pump or solenoid
valve) when changing the water, then replace
the faulty equipment.
A.W.C. fault
·
It is usually caused by water shortage or pump
failure. Please check the water source. If the
pump does not work, please replace the pump.
·
If the water level is still too low after three
consecutive water refills, an A.T.O. overtime
alarm will be triggered.
