DO NOT ENTER THE SWIMMING POOL WHILE ROBO-KLEEN PLUS
IS IN OPERATION TO AVOID ENTANGLEMENT WITH CORD
Operation
a. Connect the cable to the power supply
b. Grasp the cleaner by a side handle and place ROBO-KLEEN PLUS in the
pool.
c. Rock the unit from front to back and side to side, releasing trapped air,
until the unit slowly sinks to the bottom of the pool.
d. Start the unit at a 90˚ angle to a wall . CAUTION: BE SURE MAIN LINE
OUTLET IS PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER
(GFCI) OR SERIOUS INJURY COULD OCCUR.
e. Press the top of the On/Off switch through the clear jacket on the power
supply. ROBO-KLEEN PLUS will take an initial 10 seconds to scan the
circuit board and reset the memory. After the initialization is complete,
filtered water will be pumped to the top and the unit will start moving.
CAUTION: Do not operate ROBO-KLEEN PLUS out of the water. This may
result in damage to the pump motor seals and invalidate the warranty.
Optimum water temperature for the operation of ROBO-KLEEN PLUS is
65˚ F to 90˚ F.
Cleaning Pattern Adjustment
ROBO-KLEEN PLUS features convenient cleaning
pattern adjustment. Simply adjust the knob that
controls the movement of the front wheels. At
the highest setting, the unit turns at a sharper
radius. For round pools, turn the knob to either
of the highest angles for best results. A smaller
angle works best in oval pools. Start the unit off
at the rounded end of oval pools.
This is all you need to do to adjust the cleaning
pattern. TO AVOID CABLE COILING, REVERSE
THE KNOB POSITION AFTER EACH USE SO THE
PATTERN IS REVERSED. During use, allow the
cord to lengthen out by removing coils and
giving the cleaner enough cord to easily reach
the furthest point of the pool. A coiled cord can
impede the movement of the cleaner.
5
Smaller Angle
Larger Angle
Robo-Kleen PLUS Manual:Layout 1 7/17/09 5:53 PM Page 5
