SmartPool NC71EU, Руководство по эксплуатации

Страница: 5 / 70

5
• To reattach the filter to the bottom lid, turn the filter bag right-side-out. Start at the
back where the filter bag says “PUSH” and insert the filter bead into the channel, so
that the tabs are holding the bag in near the label with the word “PUSH”, as shown in
Fig 7.
FIGURE 7
• Press the filter bead down all the way around the perimeter making sure that it is
completely seated and behind all the tabs.
• Pick up the bottom lid and turn it over so the bag hangs below it. Place the bottom lid
back into the cleaner being careful to feed the filter bag into the body of the cleaner.
MAKE SURE ALL FILTER MATERIAL IS INSIDE THE CLEANER OTHERWISE
THE LID WILL NOT CLOSE AND LATCH PROPERLY.
• Once the bottom lid is properly seated, turn the red locking clips in the opposite
direction of the arrows embossed on the bottom lid until it locks between the two raised
locks.
CABLE MAINTENANCE
In the course of using your SmartPool Scrubber60 ™ , the cord may begin to coil. Excessive
coiling can lead to improper cleaning coverage of your pool.
• To uncoil the cord, it is best that the cable is wet.
• Place the cleaner on the ground as shown below.
• Be sure to use a clear area that will allow the cord to stretch out in a straight line.
• Pull the cable so it is off the ground
• Using your fingers, roll the cable in the opposite direction that it is coiled in.
• When straight, wrap cable for storage as shown below.
STORING THE CABLE
• Loosely loop the cable as shown below.
Hold the cord close to the cleaner.
Make a roughly two foot loop with
the cord as shown.
When making loop, roll the cable
slightly in a counter clockwise
manner to maintain form. DO NOT
WRAP THE CORD TIGHTLY AROUND
OBJECTS.
WINTER STORAGE
If temperatures will regularly be below 45 degrees Fahrenheit or 5 degrees Celsius, the
cleaner and power supply should be stored indoors.