PLEASE CALL 1-888-755-4497 BEFORE RETURNING TO THE STORE.
WWW.SMART-POND.COM
OPERATION INSTRUCTIONS
1. Select a level location to build the Illumifalls kit. Begin building the
kit by placing the stones in the desired arrangement. It is very
important that the stones are level, so be sure to check that the
structure is level from front to back as well as left to right. Fig. 1
Fig.1
2. When the desired height of the reservoir is reached, the two stones
in the picture need to be cut. The pump power cord and tubing will
fit through this hole. Fig. 2
Fig. 2
3. Lay the liner over the stones. Carefully push the liner down into the
cavity until it reaches the ground. Smooth out the wrinkles in the
liner, but be sure to leave some slack to allow the liner to stretch
when the water is added. Fig. 3
Fig. 3
4. Trim the liner, leaving atleast six inches of liner on the top of the
stone. Fig. 4
Fig. 4
5. Remove the front screen from the pump and connect the prefilter to
the front of the pump. Fig. 5
Fig. 5
