Removing the X10 Address
1) Press & hold X10 Toggle Wall Switch’s Set button until X10 Toggle Wall Switch beeps
X10 Toggle Wall Switch’s LED will begin blinking
2) Press & hold X10 Toggle Wall Switch’s Set button until X10 Toggle Wall Switch beeps again
X10 Toggle Wall Switch’s LED will continue blinking
3) Using an X10 controller, send the X10 address you want to remove followed by the ON command
three times.
For example, to remove the address A1, send “A1 ON A1 ON A1 ON”.
X10 Toggle Wall Switch will double-beep and its LED will stop blinking
Advanced Features
Dimming/Brightening the Status LED
1) Press & hold X10 Toggle Wall Switch’s Set button until X10 Toggle Wall Switch beeps
X10 Toggle Wall Switch’s LED will begin blinking
2) Press & hold X10 Toggle Wall Switch’s Set button until X10 Toggle Wall Switch beeps again
X10 Toggle Wall Switch’s LED will continue blinking
3) Press & hold X10 Toggle Wall Switch’s Set button until X10 Toggle Wall Switch beeps a third time
X10 Toggle Wall Switch’s LED will stop blinking and turn on solid
4) Use the toggle to brighten or dim the LED to the desired brightness
Press & hold the toggle up to brighten
Press & hold the toggle down to dim
5) Once you have reached the desired brightness for the LED, tap the Set button once
X10 Toggle Wall Switch will beep
Factory Reset
1) Gently pull the Set button at the bottom of the toggle out as far as it will go (about 1/8 inch) to remove
all power to X10 Toggle Wall Switch
The LED and the load will turn off
2) Wait 10 seconds, and then push the Set button in as far as it will go and hold until X10 Toggle Switch
beeps
A few seconds after you release the Set button, X10 Toggle Wall Switch will double-beep
and its
LED and load will turn on
Specifications
View specifications for X10 Toggle Wall Switch at:
www.smarthome.com/X10WS467.html
Page 6 of 7 X10WS467 Rev: 10/7/2011 6:14 PM
