OPERATION
Read and understand all safety precautions in this manual before operating.
Failure to comply with instructions in this manual could result in personal injury,
property damage, and/ or voiding of your warranty.
1. Hold the tool securely
using the housing as a
handgrip. Do not
depress tool nose until
tool is in driving position
and you are ready to
drive a nail.
2. Position the nail on the
workpiece, placing the
nail point in driving
position at the desired
driving location.
IMPORTANT
- If nail is
being driven to secure a joist
hanger or other metal
connector, make sure nail
point is centered in punched
hole in connector.
3. Press the tool firmly to
begin driving the nail,
and continue pushing
until the nail is fully
driven. Use firm, steady
pressure.
4. After the nail is fully driven, lift the tool off of the work surface.
5. Reload the nailer, and place the tool in position for the next nail
to be driven.
6. Repeat steps 1 through 5 until all desired nails have been driven.
7. Increase air pressure to drive into harder materials. Reduce air
pressure to drive into softer materials. For longest tool and part
life, always use the lowest air pressure necessary to drive
fasteners.
8. Disconnect tool from air supply when nailing is completed.
