Controller IR per climatizzatori, pompe di calore e stufe
Manuale e specifiche tecniche
3
Installation
ATTENTION!
Before installing the device, power it with battey or MIcroUSB (not included)
and carry out the inclusion procedure.
Note:
if you decide to power the controller by battery (2 x AA not included) the FLiRS
(Frequently Listening Routing Slave) mode will be activated immediately. It will allow a great
saving of the battery thanks to the suspension of the device when it isn’t in use. The
response of the Z-Wave command will therefore have a latency of 1-2 seconds longer than
the MicroUSB power supply.
Assembly
The IR controller should be mounted on an interior wall at a height of 1.5m from the floor,
where it can be easily affected by the room temperature. Before assembly, check the best
place for installation to avoid damaging the device. The suitable place to fix the controller is
a place where there are no objects that could block the communication between it and the
air conditioner, stove or heat pump.
Note:
Avoid mounting near equipment that heats up during use (es. TV, radiator,
refrigerator).
Note:
Avoid mounting in places in direct sunlight, drafts or in some enclosed space.
Once you have found the place, follow the instructions:
•
Place the controller on the wall and mark the hole locations with a pencil.
•
Drill the holes in the positions just marked, then insert the wall plugs supplied.
•
Insert and fix the screws as shown in the figure.
Assembly note:
•
It is recommended to install the controller so that the black stove is aligned with the
