Controller IR per climatizzatori, pompe di calore e stufe
Manuale e specifiche tecniche
4
IR receiver, so that the MyVirtuoso Home device communicates directly with the air
conditioner or heat pump.
•
Within a radius of 5 meters, the device sends the command in from the alignment
with the IR receiver, however it is highly recommended to install the controller with
the black part aligned with the IR receiver of the device we want to control.
•
The range of action is about 10 meters in an open field, the further you move it, the
more difficult it will be to send commands, so it is recommended to stay within this
range.
Inclusion
Before starting the procedure for including the device in a Z-Wave network, make sure that
the MyVirtuoso Home gateway is in inclusion mode (refer to the relevant manual available
on the website
www.myvirtuosohome.com/en/downloads
1.
Quickly press the pairing button 3 times within 1 second. The controller will enter
into inclusion mode and the green LED will flash 2 times.
Note:
if a red LED flashes twice, the inclusion procedure was not successful. It is
necessary to repeat the procedure.
Note:
if the inclusion procedure does not work, try to exclude and/or reset the device to
factory settings and try to include again.
Exclusion
Before starting the procedure for including the device in a Z-Wave network, make sure that
the MyVirtuoso Home gateway is in exclusion mode (refer to the relevant manual available
on the website
www.myvirtuosohome.com/en/downloads
1.
Quickly press the pairing button 3 times within 1 second. The controller will enter
into exclusion mode and the green LED will flash 2 times.
Note:
if a red LED flashes twice, the exclusion procedure was not successful. It is
necessary to repeat the procedure.
Reset
It is possible to reset the device to factory settings without having to involve the MyVirtuoso
Home gateway.
ATTENTION!
Perform this procedure only if the gateway is not operational.
