Page 35 of 80
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
2.7. Remote Bridge Configuration
The airHaul units can also be configured to operate as a Remote device to associate with Root
Bridge. In Remote mode, the unit can operate as a bridge or a router.
Follow the steps in section 2.7.1 to 2.7.5 to configure the device in Remote Bridge mode
.
2.7.1 Ethernet Configuration
The Ethernet IP is configured during the operational mode change to Remote Bridge mode.
Follow these steps below if you need to re-configure the Remote Bridge Ethernet parameters:
1. From
the
Summary Information
page, click on the
Ethernet Configuration
link to change
Ethernet parameters.
2. Enable or disable the DHCP by clicking the check box. Enter the
‘IP address’
,
‘IP mask’
,
‘Gateway’
for non DHCP. Give the unit a unique IP Address on the same IP subnet (e.g.
192.168.0.100) as the Root Bridge unit.
3. Click on the
‘Apply Changes’
button to change the settings.
Figure 2-20 Remote Bridge Ethernet Configuration
