Submenu setting
Description
Projector Mode
Adjusts the projection mode to
Front
,
Ceiling
,
Rear
or
Rear Ceiling
.
I
I M P O R T A N T
SMART recommends that you never change this setting from the
Ceiling
projection mode.
Source
Adjusts the input source to
VGA-1
,
VGA-2
,
Composite
,
S-Video
or
HDMI
.
USB Control settings
This menu allows you to associate a video source with a USB receptacle on the ECP.
Submenu setting
Description
USB1 Source
Enables touch for the selected video source (
VGA-1
,
VGA-2
,
HDMI
or
Disabled
) by associating the video source with the room computer
USB receptacle (USB1) on the ECP.
USB2 Source
Enables touch for the selected video source (
VGA-1
,
VGA-2
,
HDMI
or
Disabled
) by associating the video source with the laptop USB
receptacle (USB2) on the ECP.
T
T I P
These settings are only available for SMART UX60 projectors running DLP firmware version
1.0.0.4 or later.
Network settings
This menu allows you to use or not use Dynamic Host Control Protocol (DHCP) and to set the
network-related addresses and names when DHCP is not used.
Submenu setting
Description
DHCP
Determines if the projector’s IP address and other network settings
are dynamically assigned by a DHCP server or manually set.
l
On
allows the network’s DHCP server to assign a dynamic IP
address to the projector.
l
Off
allows you to manually set the projector’s IP address and
other network settings.
IP Address
Displays or allows you to set the projector’s IP address in values
between 0.0.0.0 and 255.255.255.255.
Subnet Mask
Displays or allows you to set the projector’s subnet mask number in
values between 0.0.0.0 and 255.255.255.255.
Gateway
Displays or allows you to set the projector’s default network gateway
in values between 0.0.0.0 and 255.255.255.255.
A P P E N D I X
A
Remotely managing your system through a network interface
63
