Operation in a Unicable System
28
To activate the desired mode, select
Start
and press
OK
.
6.19.3 Enabling Automatic RAPS Updates
Select
Auto RAPS-Scan
to set - using the keys
V+ / V-
- whether the channel list should be
updated always at shut down (
On
) or not (
Off
). Factory setting is
Auto RAPS-Scan
On
.
7 Operation in a Unicable System
7.1
About Unicable
The receiver can be operated in a unicable system. Depending on the type of system it is possible to
connect up to eight receivers to one trunk line.
In order to achieve that, at each receiver in the setup menu, a separate IF channel and a correspond-
ing frequency must be set.
The allocation of channels and frequencies depends on the used LNBs or multiswitches.
The data sheet and the technical documentation for your LNB and / or multiswitch contain a mapping
table similar to the following.
7.2
Allocation of ZF Channels and Frequencies
Receiver
ZF channel
Sample frequency [MHz]
Frequency [MHz]
Receiver 1
1
1284
Receiver 2
2
1400
Receiver 3
3
1516
Receiver 4
4
1632
Receiver 5
5
1748
Receiver 6
6
1864
Receiver 7
7
1980
Receiver 8
8
2096
Enter the frequencies of your receiving system in the last column of the table
so that you can always have an overview of all relevant data at a glance. The
rule of thumb is: maximum frequency
shortest cable path.
7.3
Installation
Switch on the receiver.
Press
MENU
on the remote control
Select
Installation
using the
and
keys and press
to confirm.
Enter the password (on delivery
0000
is preset). The Installation menu is displayed.
Select the menu item
Antenna Setup
and confirm.
Select the menu item
LNB Freq.
and select
Unicable (9750-10600)
.
